Individual dental impression tray.

Use Tray Material thickness .125 or .150.

1. On the resulting model, smooth the undercuts with a blocking compound and create, if necessary, a space (for teeth, etc.). The model should be as low as possible from the base.

2. Place the model on the vacuum table, fix the material in the frame.

3. If necessary, place a spongy layer (spacer foam) on the model.

4. Heat the material and wait for 3-4 cm sinking. Turn on the vacuum and quickly lower the frame onto the model. Move aside the heating element. For 30 seconds, watch the adaptation process by compressing the material on the model with a wet towel.

5. Turn off the vacuum and heating element.

6. Use the tongs to pull the soft material in the center for the handle.

7. Allow the material to cool.

8. Cut an individual spoon with a laboratory plastic cutter or circular cutter.

9. Smooth down and finish the edges of an individual spoon.

Последнее изменение: Воскресенье, 18 ноября 2018, 14:04